Need help?Do you have a question about the XTZ EDGE A2-400 and is the answer not in the manual?
General| Type | Class D |
|---|---|
| Channels | 2 |
| Power output per channel (4 ohms) | 400 W |
| Frequency Response | 20Hz - 20kHz (±0.5dB) |
| Input Impedance | 10kΩ |
| Weight | 13.5 kg |
| Damping Factor | >200 |
| Signal to Noise Ratio | >100dB |
| THD | < 0.005% |
Follow all instructions, avoid water, ensure proper ventilation, and use specified accessories.
Do not expose to moisture, ensure protective earthing, and refer servicing to qualified personnel.
Connect speakers and pre-amp, set volume, connect power, configure switches, and turn on.
Connect/disconnect when off. Use short, quality cables. Ensure correct phase and clean connections.
Details on power switch, AC inlet, fuse, and RCA loop out terminals.
Details on amplification type, power output, frequency response, and damping factor.
To Next Page
