XTZ EDGE A2-300 - Introduction; Safety Instructions; Quick Setup

4
Introduction
We would like to thank you for buying a product of the XTZ EDGE series. The electrical design of the EDGE
series o󰀨ers the ultimate sound reproduction. In order to utilize your new device in the best possible way,
please read this manual carefully before using it for the rst time. It often takes some e󰀨ort and patience to
make a HiFi system sound its best. If you don´t have any previous experience from this kind of installations,
please feel free to contact our free of charge support and we will help you. (See Support on the last page
of this manual)
- Series name - Power Amplier - Power level
-Two channels
Safety instructions
Switch o󰀨 your amplier before connecting the speakers. Make sure that the speaker cables are tightened
and have a strong connection to the speaker terminal and amplier terminal.
Make sure that the electronics are not exposed to direct sunlight or strong articial light. Listening
to high sound pressure levels over a longer period of time may harm your hearing. To avoid hearing
damage do not listen to high sound levels over a longer period of time.
Quick Setup
The initial set-up of a XTZ product is relatively easy. Please take your time reading the guidelines and more
detailed instructions on the following pages of this manual after completing the rst four steps as listed
below.
1 Connect your speakers to the SPEAKER-OUTPUT terminals of the EDGE A2-300.
2 Connect your Preamplier’s PRE OUT to the EDGE A2-300 rear panel’s INPUT port.
3 Make sure to set your Pre-amplier’s volume level to minimum.
4 Connect the AC cord to the EDGE A2-300 AC Power input and then plug into an AC outlet.
5 Set the switches in the CONTROL section on the backside of the EDGE A2-300 as you wish. If the device
is used in „AUTO ON“ Mode, it will detect any incoming signal and automatically switch from STANDBY to
ON. If used in „ALWAYS ON“ Mode, the device will always be in ON Mode.
6 Switch the POWER switch on the rear panel to the “ON” setting in order to turn the EDGE A2-300 to stand-
by mode. The Standby LED indicator embedded around the bezel of the STANDBY button will illuminate
red in case you use the device in „AUTO ON“ Mode and green in case you use it in „ALWAYS ON“ Mode
English