XTZ EDGE A2-300 - Operating the EDGE A2-300; Auto On Mode; Standby Mode; Front LED Status

11
Speaker
Placement
To achieve the best results the front speakers should be placed symmetrically in front of the listener. The
distance between the front speakers should be about 80% of the distance to the listener. In other words, the
recommended angle between the front speakers is 45°.
Finally
Please remember that good sound is a matter of taste, so you have to experiment to obtain your favorite
one. We wish you best of pleasure.
The EDGE A2-300 is designed to deliver high performance with easy management.
Auto On
When the unit is set to “Auto On” mode, the amplier requires a constant signal to stay on. In absence of a
signal the amplier switches to standby mode in ~ 8 minutes.
Standby
In standby mode the whole unit consumes less than 0,3W which surpasses the requirements of the “one watt
imitative 2013” by IEA “International Energy Agency “. The amplier powers on when a signal is present and
goes into standby mode when there is no signal anymore.
Front LED
Red LED: Device is in standby mode and waiting for a signal to turn on.
Green LED: Device is on
Adjustable Gain
• You may use the adjustable gain for other sources than regular pre-ampliers like mobile phones, media
players etc. in order to adjust for their output level.
• The adjustable gain is also a good way to balance the volume of di󰀨erent ways/drivers when using the
unit for Bi-Amping.
• Using the adjustable gain will limit the maximum power output of the device and thus protect your
speakers from possible damage when playing loud. This feature can be used as a maximum volume lock.
Stereo / Mono
In mono mode, the input Signals at the left and right RCA Input are accumulated and both Output channels
will reproduce this accumulated Signal. In case only one Input channel is used, the Signal from that channel
will be distributed to both Output channels.
e.g.
- Use the stereo mode when using the amplier in a regular stereo system.
- Use the mono mode when using the amplier for Bi-Amping with a single speaker.
Operating EDGE A2-300