EN 8 EN 9
Note:
1. Install 2 pieces of AAA batteries into the remote controller before using it. Do not combine
new batteries with old ones in remote controller, which can cause operation failure due to
insufficient power supply.
2. When using the remote controller, please make sure that the signal transmitter of the
remote controller aims at infrared signal receiver of the projector.
3. If you are not using the remote controller for an extended period, please take out batteries
to prevent batteries leakage.
The projector can be hanged on the ceiling with special hanger frame, and placed on the
stable desk to project the image according to the operating environment and requirements.
In addition, the projector can be installed with following methods:
The recommended projection distance is about 10.9ft,the shortest projection distance is 3.8ft.
The image size depends on the distance between projector and screen, there may be 3%
deviation among above listed data. Different settings cause various distances.
The projector can be hanged on the ceiling with special hanger frame, and placed on the
stable desk to project the image according to the operating environment and requirements.
In addition, the projector can be installed with following methods:
1. Please purchase an universal projector ceiling mount;
2. Remove the four rubber pads on the bottom of the projector, you will see the screw holes
and use the M5*11mm screws for installing the ceiling, and then install it.
Keep the projector at a height where its lens is axial symmetry to the screen. If this is not
possible, use the keystone correction function to adjust the projection image.If you want to
get a free projection screen,please contact us via support@yabertech.com.
Installation
1. Installation Method
2. Install on the Ceiling
1. Front projection Ceiling mount 2. Rear projection Ceiling mount
3. Front projection Desk mount 4. Rear projection Desk mount
Aspect Ratio: 16:9
Distance (ft.) Screen Size
3.8 35"
5.5 50"
7.6 70"
10.9 100"
13.1 120"
16.4 150"
21.9 200"
Screw holes
To Next Page
Loading...
Need help?
General
