Yaesu FT-897D - Contents

To Next Page

To Previous Page

Contents

CAT

Main Page

Contents2
Introduction3
Product View3
General Specifications4
Transmitter Specifications4
Receiver Specifications4
Accessories & Options5
Supplied Accessories5
Available Options5
Installation6
Power Connections6
External DC Power Source Operation6
AC Power Source Operation7
AC Input Voltage Selection (U.S.A. Users Only)7
Internal Battery Operation8
Battery Installation8
Battery Charging8
Mobile Station Grounding9
Base Station Earth Grounding9
Improper Ground Connection9
Antenna Considerations10
Mobile Antenna Installations10
Base Station Antenna Installations10
RF Field Exposure11
Electromagnetic Compatibility11
Heat and Ventilation11
Linear Amplifier Interfacing12
CW Key/Keyer Connections13
Receiver Accessories (Tape Recorder ETC)13
Adjusting the Front Bail13
Front Panel Control & Switches14
Main Dial14
Power Switch14
LCD Details15
Multi Function Row “A” ( Mfa ) [ A/B, A=B, SPL ]16
Multi Function Row "B" (Mfb) [ MW, SKIP, TAG ]16
Multi Function Row “C” ( Mfc ) [ STO, RCL, PROC16
Multi Function Row “D” ( Mfd ) [ RPT, REV, VOX ]16
Multi Function Row “E” (Mfe) [TON, -------, TDCH] ([ENC, DEC, TDCH])17
Multi Function Row “F” (Mff) [ARTS, SRCH, PMS]17
Multi Function Row “G” (Mfg) [SCN, PRI, DW]17
Multi Function Row “H” (Mfh) [SCOP, WID, STEP]17
Multi Function Row “I” (Mfi) [MTR, --------, DISP]18
Multi Function Row “J” (Mfj) [SPOT, BK, KYR]18
Multi Function Row "K" (Mfk) [TUNE, DOWN, UP]18
Multi Function Row “M” (Mfm) [IPO, ATT, NAR]18
Multi Function Row “N” (Mfn) [CFIL,--------,--------]19
Multi Function Row “O” (Mfo) [PLY1, PLY2, PLY3]19
Multi Function Row “P” (Mfp) [DNR, DNF, DBF]19
Multi Function Row “Q” (Mfq) [MONI, QSPL, ATC]19
Rear Panel Connectors20
Top & Bottom Panel Connectors21
Top Panel Switch21
Bottom Panel Connector21
A-B Switch, Meter Jack21
Operation22
Turning the Transceiver on and off22
Operating Band Selection22
Menu Quick Start22
Lcd Contrast22
Mode Selection23
Adjusting the Audio Volume Level23
Adjusting the RF Gain and Squelch23
Setting the Operating Frequency24
Stacked VFO System24
Changing the Dial Speed24
Operation on 5 Mhz Band (US Version Only)25
Receiver Accessories26
Locking Front Panel Controls26
Clarifier (RIT) - Receiver Incremental Tuning26
IF Shift27
AGC (Automatic Gain Control)27
Noise Blanker28
IPO (Intercept Point Optimization)28
ATT (Front End Attenuator)28
DSP Bandpass Filter28
DSP CW Peaking Filter29
DSP Noise Reduction (NR)29
DSP Notch Filter29
AM/FM Tuning Dial Operation30
Automatic Power-Off Feature30
Transmitter Operation32
SSB/AM Transmission32
Basic Setup/Operation32
VOX Operation32
AF Speech Processor Operation33
DSP Microphone Equalizer33
CW Transmission34
Operation Using Straight Key/External Keying Device34
Using the Built-In Electronic Keyer35
FM Transmission36
Basic Setup/Operation (FM)36
Repeater Operation36
Tone Search Scanning37
DSC Operation38
DCS Search Scanning38
Split Tone Operation38
Split Tone Frequency or DCS Code Setup38
ARTS Operation39
CW Identifier Setup39
Digital Mode Operation (SSB-Based AFSK)40
RTTY (Radio Teletype) Operation40
PSK31 Operation41
Packet (1200/9600 Bps FM) Operation41
Weather Fax Monitoring42
Time-Out Timer42
Split Frequency Operation42
Active-Tuning Antenna System (ATAS0100/-120) Operation43
Automatic Tuning43
Manual Tuning43
ATAS-100/-120 Operating Tips44
External Wattmeters44
Tuning Procedure44
Operation on 30/17/12 Meters44
FC-30 Automatic Antenna Tuner Operation45
Antenna Tuner Memory System45
Memory Operation46
QMB (Quick Memory Bank) Channels46
Memory Operation on "Regular" Memory Channels46
Split-Frequency Memory Storage46
Memory Channel Recall47
Masking ("Hiding") a Memory47
Memory Operation on "Home" Channel Memories48
Home Channel Storage48
Home Channel Recall48
Labeling Memories48
Spectrum Scope Monitor Operation49
Using the Spectrum Scope49
Smart Search Operation49
Scanning Operation50
Scanning Features50
Scan-Resume Choices50
To Choose the Scan-Resume Mode50
Scan Skip Programming (Memory Mode Only)51
Priority Channel Scanning51
Programmable Memory Scan (PMS) Operation52
Dual Watch Operation52
Operation on Alaska Emergency Frequency: 5167.5 Khz (US Version Only)53
CW Training Feature53
Programming Panel Key Functions53
Miscellaneous Settings54
Beacon Feature54
Beacon Text Storage54
Beacon Transmission (on the Air)54
Display Customization55
Display Lamp Mode55
Display Contrast55
Display Color55
Display Dimmer55
Menu Operation56
Menu Modes no 001 - no 01458
Menu Modes no 015 - no 02959
Menu Modes no 030 - no 04260
Menu Modes no 043 - no 05361
Menu Modes no 054 - no 06062
Menu Modes no 061 - no 07663
Menu Modes no 077 - no 09164
CAT (Computer Aided Transceiver Operation)65
CAT Data Protocol65
Constructing and Sending CAT Commands65
Opcode Command Chart66
Power-On Microprocessor Reset Procecures67
Cloning67
Installation of Optional Accessories68
Optional Filters:yf-122S, YF-122C, and YF-122CN68
External Automatic Antenna Tuner "FC-30" Installation69
Parts List69
Setup of Memories for Low Earth Orbit (LEO) FM Satellite Operation70
MH-59A8J Remote Microphone71

Yaesu FT-897D - Contents

Table of Contents

Other manuals for Yaesu FT-897D

Related product manuals