Yaesu FTDX5000 - TX AUDIO Group

Page 134 FTDX5000 OPERATING MANUAL
MENU MODE
TX AUDIO GROUP
151 TAUD EQ1 FRQ
Function: Selects the center frequency of the lower range
for the parametric microphone equalizer.
Available Values: OFF / 100Hz ~ 700Hz (100 Hz/step)
Default Setting: OFF
OFF: The equalizer gain and Q-factor are
set to factory defaults (flat).
100Hz ~ 700Hz: Center frequencies of 100 Hz ~ 700
Hz. You may adjust the equalizer
gain and Q-factor at this selected
audio frequency via menu items
“152 TAUD EQ1 LVL” and “153
TAUD EQ1 BW”.
152 TAUD EQ1 LVL
Function: Adjusts the equalizer gain of the low range of
the parametric microphone equalizer.
Available Values: –20 ~ 10
Default Setting: 5
153 TAUD EQ1 BW
Function: Adjusts the Q-factor of the low range of the
parametric microphone equalizer.
Available Values: 1 ~ 10
Default Setting: 10
154 TAUD EQ2 FRQ
Function: Selects the center frequency of the middle
range for the parametric microphone equalizer.
Available Values: OFF / 700Hz ~ 1500Hz (100 Hz/step)
Default Setting: OFF
OFF: The equalizer gain and Q-factor are
set to factory defaults (flat).
700Hz ~ 1500Hz: Center frequencies of 700 Hz ~
1500 Hz. You may adjust the equal-
izer gain and Q-factor at this se-
lected audio frequency via menu
items “155 TAUD EQ2 LVL” and
“156 TAUD EQ2 BW”.
155 TAUD EQ2 LVL
Function: Adjusts the equalizer gain of the middle range
of the parametric microphone equalizer.
Available Values: –20 ~ 10
Default Setting: 5
156 TAUD EQ2 BW
Function: Adjusts the Q-factor of the middle range of
the parametric microphone equalizer.
Available Values: 1 ~ 10
Default Setting: 10
150 TUN MY BAND
Function: Programs a band to be skipped while selecting
bands using the
[
CLAR
(
VFO-B
)]
knob.
Available Values: 1.8M ~ 50M / GEN / T14M / T28M /
T50M
Default Setting: 1.8M ~ 50M / GEN: ON,
T14M / T28M / T50M: OFF
To program the band to be skipped, rotate the
(
VFO-
B
)[
SELECT
]
knob to recall the band to be skipped while
selecting bands via the
[
CLAR
(
VFO-B
)]
knob, then press
the
[
ENT
]
key (one of the
[
BAND
]
buttons) to change this
setting to “OFF”. Repeat the same procedures to cancel the
setting (change the “OFF” notation to “ON”).
TUNING GROUP