Yakima HullRaiser - Securing Carrier to Crossbars; Pad Adjustment and Boat Loading; Strap Securing

1033428C-3/15
ATTACH HEX KEYS
INSERT BOLTS INTO LARGE HOLES IN BASE
Make sure bolts are fully seated in base.

hex bolts with
hex wrench
from kit.

COMPLETELY.

step 7.
Foam pads can be
moved, or offset
to support boat at
contact points.
ADJUST PADS
TIGHTEN
COMPLETELY.
LOAD THE BOAT, TIE IT DOWN

HullRaiser.

over until they hang
in front of the boat.

until it hangs at top
edge of boat.

around tower or
crossbar.


To tighten
straps, hold
and pull.
SECURE STRAPS
MightyMounts must use kit #8860007
available from your YAKIMA dealer.
Note: Some lacquer hull
finishes may stick to pads.
Protect with soft cloth.