Yakima HullRaiser User Manual

1033428C-1/15
IMPORTANT WARNING
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO
OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR
TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ
AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION
OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE
AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
Part #1033428Rev.C
HULL RAISER
(2X)
— CARRIAGE BOLT (4X)
HEAVY DUTY STRAP (2X)
— SNAP AROUND (4X)
— HEX KEY (4X)
MINIMUM CROSSBAR SPREAD 24”
MIGhTyMOuNTs
must use kit #8860007.
See your dealer.
PLUG (16 X)
WRENCH (1X)
BASE PAD (2X)
Steel Hook (2X)
Plain Strap (2X)
Plastic Tube (2X)
Buckle Strap (2X)
BOW STERN TIE DOWN

Yakima HullRaiser Specifications

General

Brand	Yakima
Model	HullRaiser
Category	Automobile Accessories
Language	English

Summary

Important Safety Warnings

Installation Guide

Crossbar Compatibility and Attachment

Choose attachment method based on crossbar type (square, round, or factory).

Base and Pad Preparation

Position carrier bases, align holes, and attach pads with plugs.

Securing Carrier to Crossbars

Insert bolts into base holes and tighten completely using the hex wrench.

Pad Adjustment and Boat Loading

Adjust foam pads for contact points and begin tying down the boat.

Strap Securing

Secure straps by pressing buckles and inserting strap ends.

Bow and Stern Tie-Down

Attach buckle straps to the bow and stern of the boat.

Final Strap Tensioning and Protection

Adjust strap tension, protect vehicle with plastic tubes, and tie off excess.

Pre-Drive Checks

Test boat movement and tighten straps if loose before driving away.

Product Information and Maintenance

Weight Limits

Follow Yakima Fit List for rack weight limit; do not exceed vehicle's rack limit.

Operational Notes

Consider rear hatch clearance and antenna interference with long loads.

Maintenance and Technical Assistance

Use appropriate lubricants, clean plastic parts, and contact dealer for support.