BRAKE FLUID CHANGE, MASTER
CYLINDER
1. Open brake reservoir cover. See Figure 61.
CAUTION
Disposal of lubricants and fluids must meet local
environmental regulations.
2. Remove two capscrews, two nuts, and brake fluid
reservoir from mounting bracket on cowl. See
Figure 61.
3. Remove brake fluid reservoir cap. Pour fluid into
a suitable container with a 0.2 liter (0.42 pt)
minimum capacity. Refill reservoir with clean oil
from a sealed container and install cover on
reservoir. Correct oil is shown in Maintenance
Schedule.
4. Install brake fluid reservoir, two capscrews, and
two nuts onto mounting bracket on cowl.
5. Close brake reservoir cover. See Figure 61.
A. COVER CLOSED B. COVER OPEN
1. COVER
2. CAPSCREW
3. NUT
4. BRAKE FLUID RESERVOIR
5. MOUNTING BRACKET
Figure 61. Brake Fluid Change
BRAKE FLUID, REMOVE
Perform following procedure to remove used brake
fluid from remainder of brake system.
1. Ensure brake fluid reservoir is filled with brake
fluid.
2. Put one end of a rubber hose on special fitting of
wheel cylinder. Put other end of hose into an
empty container.
3. Loosen special fitting at wheel cylinder one turn
so that used brake fluid can be removed from
brake system. Slowly push brake pedal and hold
it at the end of its stroke. Close special fitting.
Release brake pedal.
8000 YRM 2000 Maintenance Procedures Every 2000 Hours or 1 Year
65
To Next Page
