10
Maintenance
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-lled scouring pads. Rub in direction of the grain line to
avoid scratching the surface.
Always wipe dry to avoid water marks.
• Stainless Steel Cleaner and Polish.
• Mild liquid detergent and water.
• Wipe with damp soft cloth or non abrasive sponge, then rinse
with clean water and wipe dry.
• Do not use chlorine base cleaners.
Metal Filters and Drip Trays:
1 Use 2 hands to remove lters.
2 Grasp lter handles, pull toward the front of range hood and
pull down on the rear handle to remove. Repeat for each lter.
A
A. Grease filter
3 Remove grease drip tray.
A
A. Drip tray
4 Wash metal lters and grease trays as needed in dishwasher
or hot detergent solution to clean.
5 Replace grease drip tray.
6 Reinstall lters, grasp lter handles and place front edge of
lter into the hood.
7 Push up on the back handle and set rear of lter into the drip
tray to secure. Repeat for each lter.
A
A. Grease filter
Replacing a LED Lamp
Turn o the range hood and allow the LED lamp to cool.
To avoid damage or decreasing the life of the new lamp, do
not touch lamp with bare ngers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1 Disconnect power.
2 Push up on the lens and turn it counterclockwise.
3 Remove the lamp and replace it with a 120-volt, 7.5 W watt
maximum halogen lamp with a GU10 base. Turn it clockwise to
lock it into place.
4 Repeat steps 2-3 for the other lamps if needed.
5 Reconnect power.
To Next Page
Loading...