Yale PINTR634SS

5
List of Materials
Removing the packaging.
I CAUTION
Remove carton carefully, Wear gloves to protect against sharp
edges.
I WARNING
Remove the protective lm covering the product before putting
into operation.
Supplied Part Pieces Supplied Part Pieces
Hood assembly with blower and
LED lamps already installed
1
Side spacers
2
5x45 mm
4
4x8 mm
10
10” round air transition
1
Grease lters
30”, 36”: 2
48”: 3
Parts not supplied
Tools/Materials required
• Level
• Drill
• 1¼” (3 cm) drill bit
• ⅛” (3 mm) drill bit
• Pencil
• Wire stripper or knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Flat-blade screwdriver
• Metal snips
• Phillips screwdriver
Parts needed
• Home power supply cable
• ½” (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
• 1 wall or roof cap
• Metal vent system
Optional Accesories
KIT Part #
PINSV628SS
PINTR628SS
PINTR634SS
PINSV134SS
PINTR146SS
CFM Reduction Kit ACC0185752** ACC0185099***
10" to 8" Transition Kit ACC0185271*
Kit No Blower External ACC0179547
Kit No Blower In Line ACC0179549
*There are no HVI certied ratings available for the 8" transition
Kit conguration, please check with local building codes in order
to verify compliance without HVI certication.
** CAUTION: When using this CFM reduction kit, the maximum
BTU use for this hood is 65 KBTU’s.
*** CAUTION: When using this CFM reduction kit, the maximum
BTU use for this hood is 78 KBTU’s.