Yamaha 100A - Chapter 3 Operation

GB
EMF00010
Chapter 3
OPERATION
INSTALLATION ........................................3-1
Mounting the outboard motor............3-2
FILLING FUEL AND ENGINE OIL ............3-4
Filling fuel..............................................3-4
Filling oil ................................................3-4
Gasoline (petrol) and oil mixing .........3-6
PRE-OPERATION CHECK ........................3-8
Operation after a long period of
storage...................................................3-9
BREAKING IN (RUNNING IN) ENGINE 3-10
STARTING ENGINE ..............................3-12
WARMING UP ENGINE.........................3-16
SHIFTING ................................................3-17
Forward ...............................................3-17
Reverse................................................3-17
STOPPING ENGINE ...............................3-18
TRIMMING OUTBOARD MOTOR.........3-19
Adjusting trim angle ..........................3-20
DUAL ENGINE INSTALLATION/
SINGLE ENGINE RUNNING..................3-22
TILTING UP/DOWN ...............................3-23
CRUISING IN OTHER CONDITIONS.....3-25
Cruising in salt water .........................3-25
Cruising in turbid water.....................3-25
64C-9-76 (E,F,ES) 3A 4/25/0 2:56 PM Page 70