E
EMH60010
CRUISING IN OTHER
CONDITIONS
CRUISING IN SALT WATER
After operating in salt water, wash out the
cooling-water passages with fresh water
to prevent them from becoming clogged-
up with salt deposits.
NOTE:
Refer to cooling system flushing instruc-
tions in “TRANSPORTING AND STORING
OUTBOARD MOTOR”.
CRUISING IN TURBID WATER
It is strongly recommended that the
optional chromium-plated water-pump kit
be installed if the outboard is to be used
in turbid (muddy) water conditions.
3-23
EMG64110
PROCEDURE FOR TILTING DOWN
Power trim and tilt model
1) Push the power trim and tilt switch
“UP” until the engine is supported by
the tilt rod.
2) Release the tilt-support lever.
3) Push the power trim and tilt switch
“DN” (Down) to lower the engine to
the desired position.
3) Turn the tilt-support lever toward
engine bracket and support the
engine.
w
After tilting the engine, be sure to sup-
port it with the tilt-support lever. Other-
wise, the engine could fall back down
suddenly if oil in the power trim and tilt
unit should lose pressure.
63B-9-1B-3 2/27/03 3:19 PM Page 24
To Next Page
Loading...
