4-7
GB
EMK23511
Flushing cooling system
8 Flushing in a water tank
1) Fit the outboard motor on the water
tank, and fill the tank with fresh water
to above the level of the anti-cavita-
tion plate.
2) Shift into Neutral, start the engine,
and run at low speed for a few min-
utes.
cC
If the fresh water level is below the level
of the anticavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
1 Water surface
2 Lowest water level
cC
8 Do not place the engine on its side
before the cooling water has drained
from it completely, or water may enter
the cylinder through the exhaust port
and cause problems.
8 Store the engine in a dry, well-ventilat-
ed place, not in direct sunlight.
EMK24011
Fuel Tank
1) Drain the fuel from the tank for a long
period of storage.
2) Store the fuel tank in a dry, well-venti-
lated place, not in direct sunlight.
w
The fuel tank supplied with this engine is
its dedicated fuel reservoir and must not
be used as a fuel storage container.
Commercial users should conform to rel-
evant licensing or approval authority reg-
ulations.
697-9-75 (GB,F,ES)4A 5/8/01 2:46 PM Page 148
To Next Page
