Yamaha 90C - Propeller Selection

E
6-2
N
Neutral interlock trigger ..........................2-3
Neutral throttle lever ...............................2-4
O
Oil-level indicator...................................2-11
Oil level warning/oil filter clogging
warning ...................................................2-14
Oil level warning system.......................2-15
Operation after a long period
of storage..................................................3-7
Operations of controls and other
functions ...................................................2-2
Outboard motor serial number: .............1-1
Overheat warning ..................................2-13
Overheat warning indicator..................2-11
P
Periodic maintenance..............................4-8
Power trim/tilt switch .......................2-6, 2-7
Power trim/tilt will not operate...............5-5
Pre-operation checks ...............................3-6
Propeller selection .................................1-13
R
Remote control.........................................2-3
Remote control lever ...............................2-3
Removing the propeller ........................4-19
Replacement parts...................................4-8
Replacing fuse........................................4-16
Reverse ...................................................3-14
S
Safety information ...................................1-3
Shifting....................................................3-14
Specifications ...........................................4-1
Start-in-gear protection.........................1-14
Starter will not operate............................5-6
Starting engine.......................................3-10
Stopping engine.....................................3-15
Storing outboard motor ..........................4-4
T
Tachometer...............................................2-9
Temporary action in emergency............5-5
Throttle friction adjusting screw ............2-6
Tilting up/down ......................................3-19
Tilt support lever....................................2-12
Top cowling lock levers.........................2-12
Trailering outboard motor ......................4-3
Transporting and storing outboard
motor.........................................................4-3
Treatment of submerged motor ..........5-11
Trim angle settings and boat
handling ..................................................3-18
Trim meter..............................................2-10
Trim tab.....................................................2-8
Trimming outboard motor....................3-16
Troubleshooting.......................................5-1
W
Warming up engine...............................3-13
Warning system.....................................2-13
Water leakage.........................................4-16
Warranty information .................Next page
6H3-9-1N 6 2/18/03 9:19 Page 3