EasyManuals Logo

Yamaha A3000 Upgrade Guide

Yamaha A3000
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Changes in PLAY MODE
16
Chapter 2 Upgrade Reference
Changes in PLAY MODE
PLAY - PROGRAM/SAMPLE SELECTION 95
As before, you can jump to this special screen from almost any page (with the exception
of command pages) by pushing Knob 1. The screen exists as part of PLAY mode but,
unlike other screens, can be selected directly from all modes and functions.
It is now possible to access command pages directly from this page (by pressing the
Command key).
The Knob 5 MIDI Smp (MIDI-to-sample) feature has been improved to provide
better handling of cases where a given note is assigned to multiple samples (layer-
ing). On Version 1, it was not possible to predict which of these samples the note
would select for editing. On Version 2, the note will select the relevant samples
sequentially. It is also possible to choose whether the feature works with respect to
“upper” objects only (freestanding samples, and sample banks), or “lower” objects
only (samples only, ignoring all sample banks).
Specifically, the MIDI Smp parameter now offers three settings: off, upper, and
lower (where Version 1 offered only off and on). The off setting disables the feature, as
on Version 1. The upper setting targets freestanding samples and sample banks only,
while the lower setting will target samples only (and will ignore sample banks). Ex-
amples are as follows.
Assume that you select upper; and that note C3 is set to produce sound from Sam-
ple A, Sample B, and Sample Bank C; and that Sample Bank C contains Samples X
and Y. In this case, successive input of note C3 will change the selection as follows:
Sample A Sample B Sample Bank C Sample A ...
Now assume that you select lower, and the setup is the same as above. In this case,
successive input of note C3 will change the selection as follows:
Sample A Sample B Sample X Sample Y Sample A...
The new LayerSelection parameter in the UTILITY | MIDI MIDI Smp page determines
whether the sequential selection of layered samples described here works (1) on this
page only, or (2) on all pages where the MIDI Smp input is supported. ( 40)

Other manuals for Yamaha A3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha A3000 and is the answer not in the manual?

Yamaha A3000 Specifications

General IconGeneral
Sampling Rate44.1kHz
MIDIIn/Out/Thru
TypeSampler
EffectsReverb, Chorus, Delay
DisplayLCD
StorageFloppy disk drive

Related product manuals