8-9
1
2
3
4
5
6
7
8
9
10
11
To check the transmission oil level
1. Place the ATV on a level surface.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Wait a few minutes until the oil settles, and
then check the oil level through the check win-
dow located at the right side of the crankcase.
NOTE:
The transmission oil should be between the mini-
mum and maximum level marks.
4. If the oil is at or below the minimum level mark,
remove the oil filler cap, add sufficient oil of
the recommended type to raise it to the cor-
rect level, and then install and tighten the oil
filler cap.
To change the transmission oil
1. Place the ATV on a level surface.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
1. Transmission oil level check window
2. Maximum level mark
3. Minimum level mark
1
1
3
2
1. Transmission oil filler cap
1
To Next Page
Loading...
