Yamaha BLASTER YFS200W - Pre-Operation Checks

5-1
1
2
3
4
5
6
7
8
9
10
11
EBU19200
PRE-OPERATION CHECKS
EBU19220
Pre-operation check list
Before operating this ATV, be sure to check the items listed in the following table.
NOTE:
The maintenance of some items in the table has to be performed by a Yamaha dealer. Refer to the “Periodic
maintenance and lubrication chart” on page 8-3 to determine which service should be performed by a
Yamaha dealer.
ITEM ROUTINE PAGE
Fuel
● Check fuel level in fuel tank, and add recommended fuel if neces-
sary.
● Check fuel line for leakage. Correct if necessary.
4-8, 5-4
2-stroke engine oil
● Check oil level in oil tank, and add recommended oil to specified
level if necessary.
● Check ATV for oil leakage. Correct if necessary.
5-4
Transmission oil
● Check oil level in transmission case, and add recommended oil to
specified level if necessary.
● Check ATV for oil leakage. Correct if necessary.
5-4, 8-8
Front brake
● Check operation. If soft or spongy, have Yamaha dealer bleed
hydraulic system.
● Check brake pads for wear, and replace if necessary.
● Check brake fluid level in reservoir, and add recommended brake
fluid to specified level if necessary.
● Check hydraulic system for leakage. Correct if necessary.
5-4, 8-23, 8-24, 8-25