Yamaha C-80 - Component Identification and Functions; Front Panel Controls Overview; Subsonic Filter and Rec Out Selector

AAA AAA RRERRIRERI
Q POWER SWITCH
Push to turn power on or off. Befare turning on PONE set the
VOLUME control all the way down.
PARAMETRIC EQUALIZER
€) EQUALIZER -= LOW BAND
The LOW band of the Parametric Equalizer may be used to boost
or cut any frequency in the range of 31.5 Hz to 800 Hz by a
se ectable amount. A range of frequencies is affected, centered
on the frequency selected with the FREQUENCY control, The
width of the frequency range to be adjusted is set with the
BANDWIDTH control. The amount of boost or cut is set with the
LEVEL control (— 12 dB to +12 dB).
ue iia
LEVEL De BANIJUVICRIH
Hein LOMAS Can:
-@ EQUALIZER — HIGH BAND
The HIGH band of the Parametric Equalizer may be used to
boost or cut any frequency in the range of 0.8 kHz to 20 kHz by
a selectable amount. A range of frequencies i is affected, centered
on ihe frequency selected with the FREQUENCY control, The
width of the frequency range to be adjusted is set with. the l
Pepa H control. The amount of boost or cul is set with the
EVEL control (— 12.dB to + 12 dB).
MODE SWITCH
Switches between stereo and mono modes.
ARA AA NA RR
E TEJE
lape input :
DAD a PRONG |
TARE 4 7
E i A CANIS! ip as]
€————— I A al ——— O] o enn narra
k
liest
EEEE
EREIRERE
SEINS
VRRRERCRRCERRSRSERSIURRHTS
NARA
ARENA
RETEST
TERS
PISA
RSG
SATS
state
Rabatte
© SUBSONIC FILTER
This switch cuts out ultra-low-frequency signals
warped records
ampli
caused ny
or turntable rumbie. Subsonic interference drains
Her power and can even harm speakers if not alte
REC OUT SELECTOR
This switch selects the source for recording. Monitoring the
recording source is optional: the input selector switches can be
set to the same or a different source from that being recorded. If .
your tape deck has three-head monitoring capability, you can
monitor the just-recorded signa! by pressing the corresponding
selector switch.
nuated,