How to fix a Yamaha CD-S1000 that won't turn on?
If your Yamaha CD Player isn't turning on, the power cable may not be properly connected to the AC IN inlet on the rear panel or plugged into the AC wall outlet. Ensure the power cable is firmly connected.
Why is there no sound coming from my Yamaha CD-S1000?
If you're not getting any sound from your Yamaha CD Player, there could be a few reasons. First, check the output cable connections to make sure they are properly connected. If the problem continues, the cables might be defective. Also, make sure that the amplifier controls are set to the correct input selection.
What to do if Yamaha CD Player remote control is not working?
If the remote control for your Yamaha CD Player isn't working correctly, consider these potential causes: * Make sure you are within a 6 m (20 ft) range and no more than 30 degrees off-axis from the front panel. * Reposition the unit if direct sunlight or lighting is striking the remote control sensor. * Replace all batteries, as weak batteries can cause remote malfunction.
Why does my Yamaha CD-S1000 CD Player sound keep skipping?
If the sound on your Yamaha CD Player is skipping, it could be due to a couple of reasons. The unit might be experiencing vibrations or impacts, so try relocating it. Alternatively, the disc could be dirty, so try cleaning it.
What to do if Yamaha CD Player playback does not start?
If playback on your Yamaha CD Player doesn't start, consider these possibilities: * The disc may be damaged, so check it carefully and replace if necessary. * There may be moisture on the laser pickup; wait 20 to 30 minutes after switching the unit ON before trying to play back a disc. * Ensure the disc is loaded with the label side up. * Clean the disc if it's dirty. * Confirm that the disc format (MP3 or WMA) is compatible with the unit; if not, replace it with a compatible disc. * If using a CD-RW disc, ensure it was recorded correctly; otherwise, replace it. * If the disc is non-standard, replace it with a playable disc.
Why does my Yamaha CD-S1000 CD Player sound hum?
If your Yamaha CD Player is producing a humming sound, the audio cables might not be connected properly. Make sure the audio cables are securely connected. If the problem continues, the cables may be defective.
Why is playback delayed or starting at the wrong place on my Yamaha CD-S1000?
If playback on your Yamaha CD Player is delayed or starts at the wrong place, the disc may be scratched or damaged. Check the disc carefully and replace it if necessary.
What to do if the Yamaha CD-S1000 disc tray does not close completely?
If the disc tray on your Yamaha CD Player isn't closing completely, a foreign object might be obstructing the tray. Carefully check the disc tray and remove any foreign objects.
Why is there no sound from components connected to the DIGITAL OUT jacks on my Yamaha CD-S1000 CD Player?
If you're not hearing sound from a component connected to the DIGITAL OUT jacks on your Yamaha CD Player, it could be due to one of two reasons: PURE DIRECT might be turned on (turn PURE DIRECT off, or make an analog connection), or the Super Audio CD layer might be playing (switch the playback layer, or make an analog connection).
Why is there noise coming from inside the disc tray of my Yamaha CD Player?
If you're hearing noise from inside the disc tray of your Yamaha CD Player, the disc may be warped. Try replacing the disc.
General| Frequency range | 2 - 50000 Hz |
|---|---|
| Output power description | 2 +/- 0.3 V |
| Signal-to-Noise Ratio (SNR) | 113 dB |
| Total Harmonic Distortion (THD) | 0.002 % |
| Device type | HiFi CD player |
| Product color | Silver |
| Disc loading type | Tray |
| Volume control | Digital |
| Dimensions (WxDxH) | 137 x 440 x 435 mm |
Weight and Dimensions| Weight | 15000 g |
|---|
To Next Page
