Why is my Yamaha CDX-497 CD Player remote control not working?
If the Yamaha CD Player remote control isn't working, the batteries might be weak, so try replacing them. Also, make sure you're within 6 meters and a 60° radius of the unit. Direct sunlight or certain types of lighting can also interfere with the remote control sensor, so try repositioning the main unit.
What to do if there is no sound from my Yamaha CDX-497?
If you're not getting any sound from your Yamaha CD Player, check the output cable connections to ensure they are properly connected and not defective. Also, verify that your amplifier controls are set to the correct input selection. If you have a CDX-497 model, make sure the OUTPUT LEVEL +/– buttons are not set at minimum; adjust the volume accordingly.
Why does the sound skip on my Yamaha CDX-497?
If the sound skips on your Yamaha CD Player, it could be due to vibrations or impacts affecting the unit. Try relocating the unit to a more stable surface. Additionally, a dirty disc can cause skipping, so clean the disc carefully.
What to do if my Yamaha CDX-497 CD Player playback does not start?
If playback doesn't start on your Yamaha CD Player, check the disc for damage and replace it if necessary. If there is moisture on the laser pickup, wait 20 to 30 minutes after switching the unit ON before trying again. Ensure the disc is loaded with the label side up and that it's clean. If using a CD-RW, make sure it's correctly recorded and playable with this unit. Also, make sure that the disc is a standard disc playable with this unit.
Why does my Yamaha CD Player sound hum?
If your Yamaha CD Player is humming, ensure the audio cables are securely connected. If the problem continues, the cables may be defective and need replacement.
Why is the playback delayed on my Yamaha CDX-497 CD Player?
If playback on your Yamaha CD Player is delayed or starts at the wrong place, the disc may be scratched or damaged. Check the disc carefully and replace it if needed.
How to reduce noise from tuner on Yamaha CDX-497?
To reduce noise from a nearby tuner affecting your Yamaha CD Player, move the tuner and the main unit farther apart.
What to do if TV functions strangely when Yamaha CD Player remote is used?
If your TV functions strangely when using the Yamaha CD Player remote, the remote might be interfering with the TV's remote control sensor. Try relocating the main unit away from the TV or cover the TV’s remote control sensor.
Why is there noise from inside of the Yamaha CDX-497 disc tray?
If you hear noise from inside the disc tray of your Yamaha CD Player, the disc may be warped. Try replacing the disc.
Why is there no sound from the headphones on my Yamaha CDX-497 CD Player?
If you're not getting any sound from the headphones on your Yamaha CDX-497 CD Player, check if the OUTPUT LEVEL +/– buttons are set at minimum. Adjust the volume using these buttons.
General| Frequency range | 2 - 20000 Hz |
|---|---|
| Signal-to-Noise Ratio (SNR) | 105 dB |
| Total Harmonic Distortion (THD) | 0.003 % |
| CD-RW playback | Yes |
| File type | MP3, WMA |
| Device type | HiFi CD player |
| Product color | Black |
| Dimensions (WxDxH) | 435 x 87 x 287 mm |
Weight and Dimensions| Weight | 3500 g |
|---|
To Next Page
