4
CONNECTIONS
●
Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other
components to which connections are being made.
●
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L
(left) to L, R (right) to R. Also, refer to the owner’s manual for each component to be connected to this unit.
* : Refer to “ABOUT THE ACCESSORY COMPONENTS ON THE REAR PANEL” on page 6.
* The TAPE 3 terminals gain higher Signal-to-Noise Ratio than the TAPE 1 or TAPE 2 terminals. If you will
use a Digital Compact Cassette recorder or Minidisc recorder, etc., it is recommended to connect such a
component to the TAPE 3 terminals.
<CX-1>
To Next Page
