CX-A5000
The following features were added or modified for product improvements.
For details on operation procedure for each feature, refer to the CX-A5000 Owner’s
Manual. Numbers in parentheses show the page numbers where corresponding
explanations are given.
HDMI 4K (60 Hz/50 Hz) pass-through transmission
The pass-through transmission of HDMI 4K (60 Hz/50 Hz) 4:2:0 signals becomes
available.
Additional setting for the auto-standby function
“20 Minutes” is added as the setting of “Auto Power Standby” (p.121) in “ECO” in the
“Setup” menu.
This setting sets the unit to standby mode when you have not operated the unit and no
input signals are detected for 20 minutes.
Default
U.K. and Europe models: 20 Minutes
Other models: Off
YPAO Volume
When YPAO Volume is enabled, the high- and
low-frequency levels are automatically adjusted
according to the volume so that you can enjoy
natural sounds even at low volume.
You can enable/disable YPAO Volume in “YPAO
Volume (YPAO Volume)” in the “Option” menu
(p.90).
■ YPAO Volume (YPAO Volume)
Settings
• YPAO Volume works effectively after the measurement results of “Auto Setup” have been already saved.
• We recommend enabling both YPAO Volume and Adaptive DRC when you are listening at lower volumes or
at night.
Jitter elimination level adjustment
The jitter elimination level adjustment that works on the unit’s ultra low jitter PLL circuit is
newly added. By adjusting the elimination level of jitter in digital audio, you can
enhance the DAC accuracy of the unit
You can adjust the elimination level in “Ultra Low Jitter PLL Mode” in the “Input” menu (p.95).
■ Ultra Low Jitter PLL Mode
• This setting is applied separately to each input source.
Input sources
AV 1–7, V-AUX, AUDIO 1–4 (available only when any audio digital input jack is assigned),
AirPlay, SERVER, NET RADIO, (network services), USB
Settings
Specifications
The Standby Power Consumption values were changed.
• Standby Power Consumption
Network Standby Off
HDMI Control Off, Standby Through Off ................................................................................ 0.3 W
HDMI Control On, Standby Through On ................................................................................ 3.7 W
HDMI Control Off, Standby Through On (AV 1, No Signals) .................................................. 3.7 W
Network Standby On
HDMI Control Off, Standby Through Off ................................................................................ 2.9 W
HDMI Control On, Standby Through On ................................................................................ 5.0 W
Additional Features
Off (default) Disables YPAO Volume.
On Enables YPAO Volume.
YPAO Volume OFF
YPAO Volume ON
FrequencyLow High
Level
High
Listening level at low volume
Off Disables the jitter elimination function.
Level 1 (default),
Level 2,
Level 3
Enables the jitter elimination function.
The higher level enhances the DAC accuracy, but may cause audio
interruptions on some playback devices depending on the audio
clock conditions. In this case, select lower level.
CTKGLVF
To Next Page
Need help?
General
Weight and Dimensions
