Yamaha DR2E17 - Battery Installation Details and Fuse Replacement; Battery Installation Cable and Holddown Precautions; Battery Holddown Nut Tightness Notice; Fuse Replacement Safety Warning

MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
7-7
J0C
When installing batteries:
l Carefully place battery cables
and holddowns making sure that
cables do not lay across vent caps.
l Always remove the negative (–)
cable to the motor controller first,
and install it last. A spark can
occur causing an explosion or fire
at the battery.
Do not overtighten the battery
holddown nuts. Excessive force
will damage the battery casing.
Fuse Replacement
Be sure to use the specified fuse.
Using a wrong fuse can cause
electrical system damage and
create a fire hazard. Death or seri-
ous personal injury can result
from failing to comply with the
safety instructions in this manual.
When replacing a fuse be sure
the main switch is turned off to
prevent accidental short-circuiting
and electrical system damage.
NOTICE
NOTICE
J0C-F8199-60.qxp_LIT_19626_16_05.qxd 6/27/16 2:50 PM Page 30