11
EnglishBASIC OPERATION
ADVANCED OPERA
TION APPENDIX
INTRODUCTION
PREPARATION
Connecting an Audio Component
■ PHONO terminals
These terminals are used to connect a turntable with an MM
or high-output MC cartridge. If you have a turntable with a
low-output MC cartridge, use an inline boosting transformer
or MC head amplifier when connecting to these terminals.
y
Connecting the ground (earth) wire of the turntable to the GND
terminal will normally minimize hum, but in some cases, better
results may be obtained with the ground wire disconnected.
CONNECTIONS
Be sure to connect the right channel (R), left channel (L),
input (IN) and output (OUT) properly.
Tape deck or
MD recorder
L R
L R
L R
L
R
OUTPUT
L R L R
OUTPUT OUTPUT
LINE OUT
LINE IN
GND
Turntable
(Europe model)
CD player
Analog signal
Signal flow
Tuner
0103DSP-A509-18_EN 2/29/0, 4:53 PM11
To Next Page
Loading...
Need help?
General
