43
EnglishBASIC OPERATION
ADVANCED OPERATION
APPENDIXINTRODUCTION PREPARATION
■ Returning to the factory-set codes
To return to the factory-set codes in all positions, follow
these steps.
1 Press i (right) and j (left)
at the same time for about
four seconds.
The indicator flashes twice.
2 Enter the code number
“9990”.
Make sure that the indicator
flashes twice.
PRESET REMOTE CONTROL
To return to the factory-set codes in each position, follow
these steps.
1 Set the selector dial to the
position for the
component to be returned
to the factory-set code.
2 Press i (right) and j (left)
at the same time for about
four seconds.
The indicator flashes twice.
3 Enter the code number
“0000”.
Make sure that the indicator
flashes twice.
The following codes are factory set.
Selector dial
position
Component
Code
TV TV 0101
CBL/SAT Satellite tuner 0006
VCR VCR 0002
DVD/LD DVD player 0008 (YAMAHA DVD player)
CD CD player 0005 (YAMAHA CD player)
TAPE/MD Tape deck 0004 (YAMAHA Tape deck)
AMP/TUN this unit 0003
DSP/TUN this unit 0013
We recommend that you write all the code numbers you
have set on the “Quick Reference Card”.
0108DSP-A536-43_EN 2/29/0, 4:55 PM43
To Next Page
Loading...
