EasyManua.ls Logo

Yamaha DSP-AX1600 - Page 27

Yamaha DSP-AX1600
151 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RX-V1600/DSP-AX1600
27
RX-V1600/
DSP-AX1600
Cause: The voltage in the power supply section is
abnormal.
Supplementary information: The abnormal voltage is
displayed in based on 5V as 255.
Turning on the power without correcting the abnormality
will cause the protection function to work 1 second later
and the power supply will be shut off.
When there is a history of protection
function due to abnormal voltage in
the power supply section
電源部の電圧異常によるプロテク
ション履歴がある場合
Version (1 alphabet)
バージョン(英1文字)
A/D conversion value of voltage
電圧のA/D変換値
A/D conversion value of voltage
電圧のA/D変換値
When there is a history of protection
function due to abnormal DC output
DC出力異常によるプロテクション
履歴がある場合
Version (1 alphabet)
バージョン(英1文字)
Cause: DC output of the power amplifier is abnormal.
Supplementary information: The abnormal voltage is
displayed in based on 5V as 255.
Turning on the power without correcting the abnormality
will cause the protection function to work 3 seconds later
and the power supply will be shut off.
原因:パワーアンプのDC出力が異常。
補足:異常時の電圧の状態を、5Vを255とした値で表示し
ます。
異常状態のままパワーオンすると、3秒後にプロテクショ
ンがかかり、電源が切れます。
原因:電源部の電圧が異常。
補足:異常時の電圧の状態を、5Vを255とした値で表示し
ます。
異常状態のままパワーオンすると、1秒後にプロテクショ
ンがかかり、電源が切れます。
When there is a history of protection
function due to excessive heat sink
temperature
放熱器の異常温度によるプロテク
ション履歴がある場合
Version (1 alphabet)
バージョン(英1文字)
A/D conversion value of voltage
電圧のA/D変換値
Cause: The temperature of the heat sink is excessive.
Supplementary information: The abnormal voltage is
displayed in based on 5V as 255.
Turning on the power without correcting the abnormality
will cause the protection function to work 1 second later
and the power supply will be shut off.
* Additional causes of protection can be due to loose
connections, associated components, Microprocessor,
etc.
* For the protection voltage value, refer to DIAG menu
No.12 described later.
原因:放熱器の温度が異常。
補足:異常時の電圧の状態を、5Vを255とした値で表示し
ます。
異常状態のままパワーオンすると、1秒後にプロテクショ
ンがかかり、電源が切れます。
前記の異常原因の他に、コネクターのはずれやMicro-
processor周辺などに原因がある場合があります。
プロテクションの電圧値に関しては、後述のダイアグメ
ニューNo.12を参照してください。

Related product manuals