RX-V2400/RX-V2400RDS/DSP-AX2400
RX-V1400/RX-V1400RDS/HTR-5690/DSP-AX1400
RX-V2400/RX-V2400RDS/DSP-AX2400
RX-V1400/RX-V1400RDS/HTR-5690/DSP-AX1400
24
3. Turn on the power to the unit.
4. To connect the line, click the CONNECT button or the
COM menu, then click the CONNECT.
After connecting, the "Connected" message is
displayed in the status bar.
5. To load the firmware, select the file to be loaded, click
the Program Macro button, and then click the Open
button.
<CAUTION>
Never disconnect the power cable of the unit while
loading the firmware, or the flash ROM data may be
destroyed.
6. When the firmware loading is finished, the checksum
information will be displayed on the information box.
7. To disconnect the line, click the BREAK button or click
the COM menu, then click the BREAK.
＜注意＞
COM > CONNECT Menu
For more information, access to the “FIRMWARE
UPDATE PROCEDURES” on the WEB SITE.
COM > BREAK Menu
2. After executing the firmware loading program, select
the program type and port settings as follows:
Program Type Select
COM > SETTING Menu
Port Setting Dialog
To Next Page
Loading...
Need help?
General