
Do you have a question about the Yamaha DSP-AX763 and is the answer not in the manual?
| Channels | 7.1 |
|---|---|
| Amplifier Type | Discrete |
| Total Harmonic Distortion (THD) | 0.06% |
| Response Bandwidth | 10 Hz - 100 kHz |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 4 |
| HDMI Outputs | 1 |
| Input Impedance | 47 k ohms |
| Audio D/A Converter | 192 kHz/24-bit |
| DSP Presets | 17 |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 530 - 1710 kHz |
| Preset Station Qty | 40 |
| HDMI Switching | Yes |
| Audio Inputs/Outputs | 6 Audio Inputs, 2 Audio Outputs |
| Input Sensitivity/Impedance | 200 mV / 47 k ohms |
| Frequency Response | 10 Hz - 100 kHz |
| Dimensions (W x H x D) | 435 mm x 171 mm x 377 mm |
| Dimensions (W x H x D Alternative) | 17.1 x 5.9 x 14.2 inches |
| Built-in Decoders | Dolby Digital, Dolby Digital EX, Dolby Pro Logic IIx, DTS |
| Surround Sound Effects | Dolby Digital, Dolby Digital EX, Dolby Pro Logic IIx, DTS, DTS-ES, DTS 96/24, DTS Neo:6 |
| Tuner Bands | AM/FM |
| Connector Type | RCA, HDMI |
| Surround Sound Formats | DTS Neo:6, DTS-ES Discrete 6.1, DTS-ES Matrix 6.1, DTS-HD, Dolby Digital, Dolby Digital EX, Dolby Digital Plus, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby TrueHD |
| Video Inputs/Outputs | component video input, component video output, composite video input, composite video output |
| Amplifier Output Details | 105.0 Watt - 8.0 Ohm - 20 - 20000 Hz - THD 0.06% - 7.0 channel(s) (surround) 105.0 Watt - 8.0 Ohm - at 1.0 kHz - THD 0.7% - 7.0 channel(s) (surround) |
Details components marked with 's' that require specific replacement parts.
Verifies insulation of exposed conductive surfaces after service.
Discusses recommended lead-free solder types for repair work.
Details the remote control panel for specific models (RX-V663, HTR-6160).
Details the remote control panel for specific models (RX-V663, DSP-AX763).
Details the remote control panel for specific models (RX-V663, HTR-6160, DSP-AX763).
Step-by-step instructions for removing the top cover of the unit.
Instructions for removing the front panel assembly from the unit.
Steps to remove the sub chassis unit, including associated parts.
Lists the necessary tools for firmware updating via CD.
Outlines the steps for updating firmware using a CD and DVD/CD player.
Allows selection between Analog Bypass and DSP Bypass for diagnostic testing.
Covers analog switch settings for speaker configurations like LARGE, SMALL, NONE.
Checks video circuits including I2C read/write and digital component signal paths.
Lists electrical components, their part numbers, descriptions, and abbreviations.












Loading...