Setting Parameters using Menu Mode
DTX400K/DTX430K/DTX450K Owner’s Manual
42
1-4. Number Button Lighting Pattern
You can have number buttons [1] to [10/0] light up when
playing the metronome in Kit Mode or Song Mode. Use the
following procedure to set the buttons’ lighting pattern.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [1] to select the Metronome Set-
tings parameter group.
3. Press number button [4] to select the Number Button
Lighting Pattern parameter.
4. Select a new lighting pattern using the corresponding
number button ([1] to [3]). The available settings are as
follows.
2-1. Pad Sound
Using the following procedure, you can change the sounds
assigned to the current kit’s pads. This makes it very easy to
create your own unique kits.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [2] to select the Kit Settings
parameter group.
3. Press number button [1] to select the Pad Sound param-
eter.
4. Strike a pad to select it.
5. Enter a new drum-sound number using number buttons
[1] to [10/0]. For a list of sounds and numbers, see the
Voice List (page 61).
2-2. Pad Volume
Using the following procedure, you can adjust the volume
of the current kit’s pads.
1. While holding the [KIT] button, press the [SONG] but-
ton to activate Menu Mode.
2. Press number button [2] to select the Kit Settings
parameter group.
3. Press number button [2] to select the Pad Volume
parameter.
4. Strike a pad to select it.
5. Enter a new volume using number buttons [1] to [10/0].
Steps:
MENU ([KIT] + [SONG]) [1] [4] Setting
Number button Setting
[1] Off (no lighting)
[2] Pattern 1
[3] Pattern 2
x Kit Settings
Steps:
MENU ([KIT] + [SONG]) [2] [1] Setting
Setting
1 to 169
Steps:
MENU ([KIT] + [SONG]) [2] [2] Setting
Setting
0 to 127
To Next Page
Loading...
Need help?
General
