Yamaha F75C - Page 63

E
4-6
NOTE:
A flushing attachment is available from a
Yamaha dealer.
EMU00349
Lubrication
1) Remove the spark plug(s). Spray a
Yamaha “Stor-Rite Engine Fogging
Oil” into each cylinder for 10 seconds.
Grease the spark plug threads and
reinstall the spark plug(s) and torque
to proper specification. (Refer to the
“CLEANING AND ADJUSTING
SPARK PLUG”).
2) Turn the engine over with the stop
lanyard disconnected to work the fog-
ging oil into the piston rings.
3) Change the gear-case oil. (Refer to
“CHANGING GEAR OIL”). Inspect the
oil for the presence of water which
indicates a leaky seal. Seal replace-
ment should be performed by an
authorized Yamaha dealership prior
to use.
4) Grease all grease fittings. (Refer to
the “GREASING”)
EMU00351
Cleaning and Anti-corrosion Measure
1) Wash down the exterior of the out-
board with fresh water and dry off
completely.
2) Spray the engine’s exterior with
“Yamaha Silicone Protectant” (Part
No. LUB-SILCNE-13-00).
3) Wax the cowling with a non-abrasive
wax such as “Yamaha Silicone Wax”
(Part No. ACC-11000-15-02).
67F-9-17-4 3/28/03 16:56 Page 7