Maintenance
60
5. Completely insert the dipstick and re-
move it again.
6. Check the oil level using the dipstick to be
sure the level falls between the upper lev-
el mark “” and lower level mark “” . Fill
with oil if it is below the lower level mark
“”, or drain to the specified level if it is
above the upper level mark “” .
7. Start the engine and make sure that the
low oil pressure-warning indicator re-
mains off. Also, make sure that there are
no oil leaks.
CAUTION:
ECM01621
If the low oil pressure-warning indicator
comes on or if there are oil leaks, stop the
engine and find the cause. Continued op-
eration with a problem could cause severe
engine damage. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
8. Turn off the engine and wait 3 minutes.
Recheck the oil level using the dipstick to
be sure the level falls between the upper
level mark “” and lower level mark “” .
Fill with oil if it is below the lower level
mark “”, or drain to the specified level if
it is above the upper level mark “” .
9. Dispose of used oil according to local
regulations.
NOTE:
● For more information on the disposal of
used oil, consult your Yamaha dealer.
● Change the oil more often when operating
the engine under adverse conditions such
as extended trolling.
Draining the oil by removing the oil drain
screw
1. Remove the four bolts to remove the
apron from the starboard side.
1. Oil dipstick
2. Lower level mark “”
3. Upper level mark “”
1. Oil dipstick
2. Lower level mark “”
3. Upper level mark “”
U6P272E0.book Page 60 Friday, March 16, 2007 1:22 PM
To Next Page
