To Next Page
J
Jeffrey AndersonSep 8, 2025
What to do if I cannot use the Auto Punch In/Out function on my Yamaha MD4?
- Ppatrick48Sep 8, 2025
To access the Auto Punch In/Out function on your Yamaha Minidisc Recorder, you must set the LAST REC IN and OUT points.
What to do if I cannot use the Auto Punch In/Out function on my Yamaha MD4?
To access the Auto Punch In/Out function on your Yamaha Minidisc Recorder, you must set the LAST REC IN and OUT points.
How to access the Punch Off Line function on my Yamaha Minidisc Recorder?
To access the Punch Off Line function on your Yamaha Minidisc Recorder, you must set the LAST REC IN and OUT points.
Why can't I create a Cue List on my Yamaha Minidisc Recorder?
If you cannot create a Cue List on your Yamaha Minidisc Recorder, make sure that the selected song contains some markers.
What to do if my Yamaha Minidisc Recorder doesn't play the Cue List?
If your Yamaha Minidisc Recorder doesn't play the Cue List, make sure all steps in the Cue List are not set for zero repeats (n=0). Also, ensure that cues are entered in the correct order (e.g., “s–>e” or “3–>4”, not “e–>s” or “4–>3”).
Why does my Yamaha MD4 Minidisc Recorder show 'No Disc' when a disc is loaded?
If your Yamaha Minidisc Recorder shows 'No Disc' when a disc is loaded, make sure that the disc is loaded correctly.
General| Type | 4-track MiniDisc recorder |
|---|---|
| Number of Tracks | 4 |
| Sampling Rate | 44.1 kHz |
| Bit Depth | 16-bit |
| Recording Format | Minidisc (MD) |
| Frequency Response | 20 Hz to 20 kHz |
| S/N Ratio | 90dB |
| Inputs | 4 x XLR/TRS combo |
| Outputs | 2 x RCA |
| EQ | 2-band EQ per channel |
| Effects | Reverb, Chorus, Delay |
| Recording Time | Up to 74 minutes (using 74-minute MiniDisc) |
| Signal-to-Noise Ratio | 90dB |
| Power Supply | AC 120V, 60 Hz |
| THD | Less than 0.05% |
