Instrument and control functions
4-8
4
can be set to either “AVE_ _._ km/L” or
“AVE_ _._ L/100 km”, or “AVE_ _._
MPG” when using miles. To switch the
fuel consumption measurement units,
push the “TRIP” switch until the mea-
surement units change.
“AVE_ _._ km/L”: the average dis-
tance that can be traveled on 1.0 L
of fuel.
“AVE_ _._ L/100 km”: the average
amount of fuel necessary to travel
100 km.
“AVE_ _._ MPG”: the average dis-
tance that can be traveled on 1.0
US gal of fuel.
To reset the display, change the
display to the average fuel con-
sumption display, and while the
digits are flashing, push the “IN-
FO” switch until it is reset.
After resetting, “_ _._” is shown
until the vehicle has traveled some
distance.
EAU90710
Coolant temperature display
This display shows the coolant tem-
perature from 104 °F to 242 °F in 1 °F
increments.
If the message “Hi” flashes, stop the
vehicle, then stop the engine, and let it
cool. (See page 7-37.)
When the coolant temperature is
below 104 °F, “Lo” will be dis-
played.
The coolant temperature varies
with changes in the weather and
engine load.
EAU90684
Air temperature display
This display shows the air temperature
from 14 °F to 210 °F in 1 °F increments.
The temperature displayed may vary
from the actual ambient temperature.
When the temperature is below 14 °F,
“Lo” will be displayed.
1. Coolant temperature display
1. Air temperature display
UBAT10E0.book Page 8 Friday, November 6, 2020 6:08 PM
To Next Page
Loading...
