EasyManua.ls Logo

Yamaha MTN690-U - Engine overheating

Yamaha MTN690-U
106 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EAU86420
En
gine overheating
EWAT1041
WARNING
l Do not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may be blown
o
ut under pressure, which could cause serious injury. Be sure to wait until the engine has cooled.
l Place a thick rag, like a towel, over the radiator cap, and then slowly rotate the cap counterclockwise to the
detent to allow any residual pressure to escape. When the hissing sound has stopped, press down on the cap
while turning it counterclockwise, and then remove the cap.
Wait until the 
engine has cooled.
Check the coolant level in the 
reservoir and radiator.
The coolant level 
is OK.
The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer check
and repair the cooling system.
Add coolant. (See TIP.)
Start the engine. If the engine overheats again, have a 
Yamaha dealer check
and repair the cooling system.
There is
leakage.
There is 
no leakage.
TIP
If coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended cool-
an
t as soon as possible.
Periodic maintenance and adjustment
7-34
7

Table of Contents