24
GUIDED TOUR
Changing the Volume and Pan Settings of a Part
Now that you’re playing two Voices at the same time, you may want to ad-
just their settings. Here, we’ll change the Volume and Pan settings of one
Part’s Voice.
Operation
1
Use the PAR T q buttons to select the desired Part (Part 1 or 2).
2 Use the SELECT w buttons to call up the “Volume” display
below.
Current Volume setting.
3 Use the VA L U E q buttons or data dial to change the setting,
and play the keyboard as you make changes.
4 Now that you’ve adjusted the Volume balance of the two Voices,
change one of the Part’s Pan setting. Use the SELECT w but-
tons to call up the “Pan” display below.
Current Pan setting.
5 Use the VA L U E q buttons or data dial to change the setting,
and play the keyboard again as you make changes.
If you want, try making changes to some of the other Part controls. The
procedure is the same: 1) Use the PART q buttons to select a Part, 2)
use the SELECT w buttons to choose the desired control, and 3) use
the VALUE q buttons or data dial to change the setting. For more
information on the Part controls, see page 40.
To Next Page
Loading...
Need help?
General
