Yamaha MX-800/U - Page 10

B Heavy-gauge speaker cords
First, unscrew and remove the plastic wire holders. Insert the
stripped ends of the speaker cords into the holders until they
protrude on the other side.
Splay the strands as shown, then screw the wire holders back on.
CAUTION: |
When insering the stripped ends of the speaker cords as shown
above, make sure at least 1/16 inch (1.6 mm) of insulation is insid
the wire holders (i.e. no exposed wire is visible) and no loose
conductor wire strands are protruding after connection. To preven
speaker wires from coming loose, make sure wire holders are
firmly screwed in.