Yamaha MX360 - Engine Stopping Procedures

23
Operation
5. Turn the engine switch to “ ” (START).
Take your hand off the switch immediately after the
engine starts.
6. After the engine starts, warm up the engine
enough so that the engine does not stop when the
choke lever is returned to the original position.
7. Set the throttle lever in desired position.
Stopping the engine
MX175/MX200
1. Move the throttle lever fully in the arrow direction.
1
1.
“” (START)
If the engine fails to start, release the switch, wait a
few seconds, then try again. Each attempt should
be as short as possible to preserve the battery. Do
not crank the engine more than 5 seconds on any
one attempt.
NOTICE
701-033
1
1. Original position
12
1.
“ ”: Decrease engine speed
2.
“ ”: Increase engine speed
1
1. Throttle lever
7VE-F8199-72-E0.book 23 ページ ２０１８年６月１３日 水曜日 午後３時１５分
Downloaded from ManualsNet.com search engine