EasyManua.ls Logo

Yamaha MX800 - Page 28

Yamaha MX800
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
21
Troubleshooting
3. Check the air filter.
a. Check the air filter element clogging.
Clean or replace if clogged.
4. Check the fuses.
a. Remove the fuse holder from the fuse holder
bracket.
b. Replace the blown fuse with one of proper
amperage.
TIP
If the fuse immediately blows again, consult a
Yamaha dealer.
For the 30 A fuse, there is identification red tape on
the wire harness.
c. Install the fuse holder to the original position.
Be sure to use specified fuse. A wrong fuse will
cause electrical system damage and A FIRE HAZ-
ARD.
To prevent accidental short circuiting, be sure stop
the engine before replacing the fuse.
WARNING
NOTICE
1. Fuse holder
2. Fuse holder bracket
1. Fuse
Specified fuse:
30 A 1, 10 A 2
7UD-F8199-61-1E0.book 21 ペー 2016年6月14日 火曜日 午前11時39分

Table of Contents

Related product manuals