EasyManua.ls Logo

Yamaha MX800 - Air Filter

Yamaha MX800
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
Periodic maintenance
11. Turn the engine off and wipe the engine oil dipstick
clean, insert it back into the oil filler hole (without
screwing it in), and then remove it again to check
the oil level.
TIP
The engine oil should be between the minimum and
maximum level marks.
12. If the engine oil is below the minimum level mark,
add sufficient oil of the recommended type to raise
it to the correct level.
13. Install and tighten the oil filler cap.
Air filter
1. Unhook the holding clips, and then remove the air
filter case cover from the air filter case.
2. Pull the air filter element out.
3. Replace the air filter element and check condition
of inner element. If inner element is damaged or
dirty, replace it.
4. Install new element(s) into the air filter case.
1. Minimum level mark
2. Maximum level mark
3. Engine oil dipstick
4. Oil filler cap
1. Air filter case cover
2. Holding clip
3. Air filter case
1
2
34
5
1. Dust cap
2. Air filter case cover
3. Air filter element
4. Inner element
5. Air filter case
7UD-F8199-61-1E0.book 15 ペー 2016年6月14日 火曜日 午前11時39分

Table of Contents

Related product manuals