RX-E600/NX-E400
RX-E600/NX-E400
35
Description of main system operation
1) POWER ON/OFF processing [(1) to (4)]
(U, C, R, A, B, G, E, L models only )
R, A, G, J models only
KX
RX CDX MDX
• The power cord of each unit is connected to the AC
outlet in series and switched on and off through the RX
relay.
• Turning off the RX power switch will turn off the power to
other units (primary connection) but turning off the
power switch of any other unit will turn off the secondary
connection of each unit only (i.e., the microprocessor
remains on).
• Each unit has a backup function to save the secondary
connection status when unplugged (taking use of a unit
alone into consideration)
• The indicators of units are turned on after a dimmer level
signal is fed from RX so that they light up
simultaneously when the RX power switch is turned on.
However, as the indicator of a unit does not light up
when the unit is used alone in this setting, the indicator
is forced to turn on when 2 seconds have elapsed
without a dimmer level signal being fed (and the power
for the backup function is turned on). When the CD unit
is used alone, the timer play mode is set regardless of
the backup function status.
• Make sure that the power off processing of each unit
has been completed before turning off the power by
using the RX relay.
2) FUNCTION [(5) to (6)]
• No source other than that selected by the input selector
will be reproduced.
• The functions are selected automatically to be suitable
for the source to be reproduced.
• Selecting the functions is prohibited during recording.
3) TIMER operation [(7) to (8)]
• TIMER PLAY to start reproduction at a specified time
• TIMER REC to start recocording at a specified time
4) AUTO POWER OFF [(9)]
The RX power is truned OFF when the FUNCTION
setting is other than TUNER and AUX and no key
operation has been made for half an hour while all the
connected units are at stop.
5) AUTO POWER ON [(10)]
If the power of the connected units has been turned off
while the RX power is on and when a key involving
reproduction is pressed, the power is turned on
automatically.
6) Dimmer
There are 7 dimmer level settings. The dimmer level data
is transmmitted from the receiver when the power is
turned on. The dimmer level is “0” when a unit is used
alone.
主なシステム動作の説明
To Next Page
Loading...
