Yamaha RM804 - Yamaha RM804 Technical Specifications; Performance Specifications; Input and Output Characteristics

SPCIFICATI ONS, INPUT/OUTPUT SPECIFICATIONS
FREQUENCY RESPONSE CROSSTALK ..
+0, —3dB, 20Hz to 20kHz Less than —60dB @ 1kHz adjacent inputs.
+0, —0.5dB, 30Hz to 15kHz | . Less than —60dB @ 1kHz input to output.
TOTAL HARMONIC DISTORTION (THD) VU METERS |
Less than 0.196 @ OdB, 20Hz to 20kHz 6 illuminated meters, 4 for РСМ 1 ~ 4 and 2 for
HUM AND NOISE (6dB/Octave filter at 12.47kHz) STEREO L-R (OVU = —10dB).
—1274dB Equivalent input noise (EIN); . PEAK INDICATORS
—100dB residual output noise all faders down. 1 LEDs built into each Input channel and 1 in each VU
—90dB РСМ OUT; РОМ Master level control at maxi- meter. Input LEDs turn on RED when the signal after
mum level and all channel assign switches off. the GAIN control reaches or exceeds 3dB below clipping.
—80dB STEREO OUT; STEREO Master fader at Meter LEDs turn on 10dB below clipping.
maximum and ail channel STEREO mix FINISH
controls at minimum level. я А
—80dB ECHO SEND; ECHO SEND level control at Black painted panels, rosewood veneer cabinet, color
. . coded knobs.
maximum and all channel ECHO mix
controls at minimum level. POWER REQUIREMENTS 120V. 60H
Ядат ‚5. anadian Models: 7
MAXIMUM VOLTAGE GAIN . i e
6098: MIC IN to РСМ OUT General Model: 110 — 120/220 — 240V, 50/60Hz
10dB; TAPE IN to PGM OUT POWER CONSUMPTION
70dB; MIC IN to STEREO OUT U.S. & Canadian Models: 27W
10dB; TAPE IN to STEREO OUT General Model: 30W
60dB; MIC IN to ECHO OUT DIMENSIONS (W x D x H)
84dB; MIC IN to MONITOR OUT | 488 тт x 161 mm x 508 mm (19-1/4" x 6-3/8" x 20")
..
20dB;
ECHO
RETURN
to
РСМ
OUT
метит
аср WEIGHT
CHANNEL EQUALIZATION 12kg (26.5 Ibs)
LOW +15dB at 100Hz, shelving.
MID +15dB at 2kHz, peaking.
HIGH +15dB at 10kHz, shelving.
€ INPUT CHARACTERISTICS
MIC 50 ~ 2502 MIC | —70d8 (0.245mV) | -60dB (0.775mV) | —30dB (24.5mV)
INPUT p токо XLR-3-31
LINE 6000 LINE |—30dB (24.5mV) |—20dB (77.5mV) | 10dB (2.45V)
"Мах. Бойс
| Tape | [тока | 6000 LINE |-209В (77.5mV) |—10dB (245mV) 20dB (7.75V) Pin Jack
ECHO RETURN (L, R) | | 5R | 6000 LINE |—30dB (24,5mV) |—20dB (77.5mV) 20dB (7.75V) Phone Jack
2TRKIN(L,R) _ 6000 LINE |—20dB (77.5mV) |—10dB (245mV) 20dB (7.75V) Pin Jack
CH INSERT IN (chi 778) 6002 LINE |—10dB(245mV) |-109В (245mV) | 2098 (7.75\} | Pin Jack
SUB IN (ch1 ~ 4) 10ко 6000 LINE |—10dB (245mV)
е OUTPUT CHARACTERISTICS
—10dB (245mV) 20dB (7 75V)
ма: for
PGM OUT (15 тока LINE | -лоав одвти | 2048 (75i
ST OUT (L, R) 10kQ LINE —10dB (245mV) 20dB (7.75V)
ECHO SEND 10kQ LINE —10dB (245mV) 20dB (7.75V) Phone Jack
| MONITOR OUT (г, в) 10kQ LINE 4dB (1.23V) 20dB (7.75%) Phone Jack
CH INSERT OUT (сн? ^8) 10kQ LINE —10dB (245mV) 20dB (7.75V)
1002 10к LINE —10dB (245mv) 20dB (7.75V)
| 82 PHONE imW 40mW
1000 Stereo Phone Jack
| 402 PHONE 3mW | 130mW
* Sensitivity is the lowest level that will produce an output of —10dB (245m V}, or the nominal
output
level
when
the
unit
is
set
to
maximum
gain.
** All XLR connectors are floating (balanced) and transformer-isolated.
Pin and Phone jacks are unbalanced. .
е OdB is referenced to 0.775 Vr.m.s.
e All specifications subject to change without notice.
CH DIRECT OUT (ch1 ~ 8}
PHONES OUT