To Next PageTo Next PageWhy can't I tune into a station automatically on my Yamaha RX-496 Stereo Receiver?
If you're unable to tune into a desired station automatically on your Yamaha Stereo Receiver, check the AM loop antenna connections and tighten them, then rotate the antenna for the best possible reception. If that doesn't work, try using the manual tuning method.
What causes crackling and hissing noises on my Yamaha RX-496 Stereo Receiver?
Continuous crackling and hissing noises on your Yamaha Stereo Receiver can result from interference from lightning, fluorescent lamps, motors, thermostats, and other electrical equipment. Using an outdoor antenna and a ground wire may help reduce these noises, but complete elimination is difficult.
What to do if preset stations are lost on my Yamaha Stereo Receiver?
If previously preset stations can no longer be tuned in on your Yamaha Stereo Receiver, it's likely because the unit has been unplugged for an extended period. Repeat the presetting procedure to restore the stations.
Why is my Yamaha Stereo Receiver making buzzing and whining noises?
If your Yamaha Stereo Receiver is producing buzzing and whining noises, especially in the evening, it could be due to interference from a nearby television set. Try relocating the unit away from the TV.
General| Frequency Response | 10 Hz-100 kHz (+0, -3 dB) |
|---|---|
| Weight | 9.5 kg |
| Channel Separation | 50 dB (1 kHz) |
| Total Harmonic Distortion | 0.04% |
| Signal-to-Noise Ratio | 100 dB (CD) |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 522 - 1611 kHz |
| Input Sensitivity (MM) | 2.5 mV |
| Speaker Load Impedance | 8 ohms |
| FM Sensitivity | 1.0 µV (11.2 dBf) |
Essential precautions for unit installation, operation, and general usage for safety.
Key information, warnings, and specific instructions for UK models and frequency settings.
Guidance for connecting various audio components to the receiver unit.
Instructions for connecting speaker systems, including wire preparation and polarity.
Guidelines for setting the impedance selector based on speaker requirements and associated warnings.
Instructions for connecting indoor and outdoor FM/AM antennas, including necessary adapters.
Explanation of standby, input selection, volume, and headphone jack functions.
Details on tuner controls, bass/treble, balance, loudness, and RDS mode functions.
How to use the remote for basic receiver functions: tuning, volume, and input selection.
Steps for turning the unit on and selecting the desired audio input source.
Guidance on choosing speaker systems and adjusting the listening volume.
Instructions for manually storing desired stations and recalling them using preset numbers.
Common problems related to power, sound output, speaker balance, and hum.
Troubleshooting steps for FM/AM reception problems and non-functional remote controls.
