EasyManuals Logo

Yamaha RX-497 Service Manual

Yamaha RX-497
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SERVICE MANUAL
This manual has been provided for the use of authorized YAMAHA Retailers and their service personnel.
It has been assumed that basic service procedures inherent to the industry, and more specifically YAMAHA Products, are already
known and understood by the users, and have therefore not been restated.
WARNING: Failure to follow appropriate service and safety procedures when servicing this product may result in personal
injury, destruction of expensive components, and failure of the product to perform as specified. For these reasons,
we advise all YAMAHA product owners that any service required should be performed by an authorized YAMAHA
Retailer or the appointed service representative.
IMPORTANT: The presentation or sale of this manual to any individual or firm does not constitute authorization, certification or
recognition of any applicable technical capabilities, or establish a principle-agent relationship of any form.
The data provided is believed to be accurate and applicable to the unit(s) indicated on the cover. The research, engineering, and service
departments of YAMAHA are continually striving to improve YAMAHA products. Modifications are, therefore, inevitable and
specifications are subject to change without notice or obligation to retrofit. Should any discrepancy appear to exist, please contact the
distributor's Service Division.
WARNING: Static discharges can destroy expensive components. Discharge any static electricity your body may have
accumulated by grounding yourself to the ground buss in the unit (heavy gauge black wires connect to this buss).
IMPORTANT: Turn the unit OFF during disassembly and part replacement. Recheck all work before you apply power to the unit.
IMPORTANT NOTICE
100977
SERVICE MANUAL
STEREO RECEIVER
AMP ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . 16
IC DATA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17–18
DISPLAY DATA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
PIN CONNECTION DIAGRAM . . . . . . . . . . . . . . . . . 20
PRINTED CIRCUIT BOARD . . . . . . . . . . . . . . . . 21–27
BLOCK DIAGRAM . . . . . . . . . . . . . . . . . . . . . . . . . . . 28
SCHEMATIC DIAGRAM . . . . . . . . . . . . . . . . . . . 29–32
PARTS LIST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33–43
REMOTE CONTROL RAX100/RAX101 . . . . . . . 44–45
CONTENTS
TO SERVICE PERSONNEL . . . . . . . . . . . . . . . . . . . . 2
IMPEDANCE SELECTOR . . . . . . . . . . . . . . . . . . . . . . 3
FRONT PANELS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
REAR PANELS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4–5
REMOTE CONTROL PANELS . . . . . . . . . . . . . . . . . . 5
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . 6–7
INTERNAL VIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
DISASSEMBLY PROCEDURES . . . . . . . . . . . . . . . . . 8
SELF DIAGNOSIS FUNCTION . . . . . . . . . . . . . . . 9–15
DPX-1200
RX-497
RX-497
© 2005 YAMAHA CORPORATION. All rights reseved.
This manual is copyrighted by YAMAHA and may not be copied or
redistributed either in print or electronically without permission.
’05.11

Other manuals for Yamaha RX-497

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha RX-497 and is the answer not in the manual?

Yamaha RX-497 Specifications

Audio Specifications IconAudio Specifications
minimum RMS output power75 W + 75 W
dynamic power105/125/150/178 W
maximum output power (Europe model only)105 W
IEC output power (Europe model only)84 W
power band width10 Hz to 50 kHz
damping factor150 or more
maximum output power (Asia and General models only)115 W
maximum input signal PHONO70 mV or more
maximum input signal CD, etc.2.2 V or more
frequency response CD, etc.0 ± 0.5 dB
frequency response CD, etc. PURE DIRECT ON0 ± 1.0 dB
RIAA equalization deviation PHONO± 0.5 dB
total harmonic distortion PHONO to OUT (REC)0.02% or less
total harmonic distortion CD, etc. to SPEAKERS0.02% or less
signal to noise ratio PHONO82 dB or more
signal to noise ratio CD, etc.108 dB or more
residual noise PURE DIRECT ON100 µV
gain tracking error2 dB or less
input sensitivity/input impedance PHONO3.0 mV/47 kΩ
input sensitivity/input impedance CD, etc.185 mV/47 kΩ
output level/output impedance OUT (REC)185 mV/1.2 kΩ or less
output level/output impedance SUB WOOFER OUTPUT4 V/1.2 kΩ or less
output level/output impedance ZONE 2 OUT185 mV/1.2 kΩ or less
headphone output/impedance0.47 V/390 Ω
channel separation (CD, etc.)65/50 dB or more
tone control characteristics BASS boost/cut±10 dB
tone control characteristics BASS turnover frequency350 Hz
tone control characteristics TREBLE boost/cut±10 dB
tone control characteristics TREBLE turnover frequency3.5 kHz
continuous loudness control attenuation–30 dB
Video Specifications IconVideo Specifications
video signal type (U.S.A., Canada and General models)NTSC
video signal type (Other models)PAL
signal to noise ratio50 dB or more
frequency response (MONITOR OUT)5 Hz to 10 MHz, –3 dB
FM Specifications IconFM Specifications
tuning range (U.S.A. and Canada models)87.5 to 107.9 MHz
tuning range (Asia and General models)87.5/87.50 to 107.9/108.00 MHz
tuning range (Other models)87.50 to 108.00 MHz
usable sensitivity (IHF)1.0 µV (11.2 dBf)
signal to noise ratio (Mono/Stereo)76 dB/70 dB
harmonic distortion (Mono/Stereo)0.2%/0.3%
stereo separation45 dB
frequency response20 Hz to 15 kHz, +0.5/–2 dB
AM Specifications IconAM Specifications
tuning range (U.S.A. and Canada models)530 to 1710 kHz
tuning range (Asia and General models)530/531 to 1710/1611 kHz
tuning range (Other models)531 to 1611 kHz
usable sensitivity300 µV/m
General Specifications IconGeneral Specifications
power supply (U.S.A. and Canada models)AC 120 V, 60 Hz
power supply (Asia model)AC 220/230-240 V, 50/60 Hz
power supply (General model)AC 110/120/220/230-240 V, 50/60 Hz
power supply (Australia model)AC 240 V, 50 Hz
power supply (Europe model)AC 230 V, 50 Hz
power consumption180 W
standby power consumption0.1 W
maximum power consumption (General model only)400 W
AC outlets (Australia model)1 (Total 100 W maximum)
AC outlets (General model)2 (Total 50 W maximum)
AC outlets (Other models)2 (Total 100 W maximum)
dimensions (W x H x D)435 x 151 x 308 mm (17-1/8” x 5-15/16” x 12-1/8”)
weight8.7 kg (19 lbs. 3 oz.)

Related product manuals