Why is FM stereo reception noisy on my Yamaha RX-V430?
Noisy FM stereo reception on your Yamaha receiver can occur if the transmitter is too far away or the antenna input is poor. Check the antenna connections and consider using a high-quality directional FM antenna.
How to fix buzzing or whining noises from Yamaha RX-V430 Receiver?
If you are experiencing buzzing and whining noises, especially in the evening, it might be due to a TV set being used nearby. Try moving the Yamaha unit away from the TV.
Why is there no sound from the rear speakers on my Yamaha RX-V430 Receiver?
If you're not getting any sound from the rear speakers connected to your Yamaha Receiver, here’s what to check: * Increase the output level of the rear speakers. * If you are playing a monaural source with program 9, select another DSP program.
Why does my Yamaha RX-V430 fail to turn on?
Your Yamaha Receiver might fail to turn on due to several reasons: the power cord may not be properly connected, so ensure it is firmly connected; the IMPEDANCE SELECTOR switch on the rear panel may not be fully set, so set it fully to the left or right position; the protection circuitry may have been activated, so check all speaker wire connections; or the unit may have been exposed to a strong electric shock, in which case you should disconnect the power cord, wait 30 seconds, and then plug it back in.
Why is there no sound from the effect speakers on my Yamaha RX-V430?
If you are not getting any sound from the effect speakers on your Yamaha Receiver, here’s what you should check: * Make sure the sound effect is turned on by pressing STEREO/EFFECT. * If you are using a Dolby Surround, Dolby Digital, or DTS decoding DSP program with material not encoded with these formats, select another DSP program.
Why is there no sound from the subwoofer on my Yamaha RX-V430 Receiver?
If you're not hearing any sound from the subwoofer connected to your Yamaha Receiver, here's what to check: * If you are playing a Dolby Digital or DTS signal, and '1D BASS' in the SET MENU is set to MAIN, change it to SWFR or BOTH. * If you are playing a 2-channel source, and '1D BASS' in the SET MENU is set to SWFR or MAIN, change it to BOTH.
How to fix no sound from the subwoofer on Yamaha Receiver?
If there is no sound from the subwoofer, and “1D BASS” on the SET MENU is set to MAIN when a Dolby Digital or DTS signal is being played, select SWFR or BOTH. If “1D BASS” is set to SWFR or MAIN when a 2-channel source is being played, select BOTH.
How to fix no sound from the rear speakers on Yamaha RX-V430 Receiver?
If there is no sound from the rear speakers, raise the output level of the rear speakers. Also, if you are playing a monaural source with program 9, select another DSP program.
How to fix no sound from the center speaker on Yamaha RX-V430?
If there's no sound from the center speaker, raise the level of the center speaker. Also, check that “1A CENTER” on the SET MENU is set to the appropriate mode for your center speaker. Finally, if one of the Hi-Fi DSP programs (1 to 4) has been selected (except for 5ch Stereo), select another DSP program.
What to do if there is no sound from effect speakers on Yamaha RX-V430?
If there is no sound from the effect speakers, ensure that the sound effect is turned on by pressing STEREO/EFFECT. Also, if you are using a Dolby Surround, Dolby Digital or DTS decoding DSP program, make sure the material is encoded with Dolby Surround, Dolby Digital or DTS. If not, select another DSP program.
To Next Page
General