How to eliminate crackling and hissing noises on Yamaha RX-V670?
Continuous crackling and hissing noises on your Yamaha Stereo Receiver can result from lightning, fluorescent lamps, motors, thermostats, and other electrical equipment. Using an outdoor antenna and a ground wire may help reduce the noise, but it's difficult to eliminate it completely.
How to eliminate buzzing and whining noises on Yamaha Stereo Receiver?
If your Yamaha Stereo Receiver is experiencing buzzing and whining noises, especially in the evening, it may be due to a nearby television set. Try moving the television away from the receiver.
Why is the volume low when playing a record on my Yamaha RX-V670?
If the volume level is low when playing a record on your Yamaha Stereo Receiver, it might be because you're using a turntable with an MC cartridge. In this case, the player should be connected to the unit through an MC head amplifier.
What to do if there is distortion and clear reception cannot be obtained even with a good FM antenna on Yamaha RX-V670?
If you're experiencing distortion and cannot get clear reception even with a good FM antenna on your Yamaha Stereo Receiver, there may be multipath interference. Try adjusting the antenna placement to eliminate this interference.
How to fix Yamaha RX-V670 Stereo Receiver if the distance or range within which the remote control transmitter can be used decreases?
If the effective range of your Yamaha Stereo Receiver's remote control transmitter has decreased, the batteries may be weak. Replace them with new ones.
General| Power Output | 100 W per channel (8 ohms, 20 Hz - 20 kHz, 0.06% THD) |
|---|---|
| Channels | 7.2 |
| Frequency Response | 10 Hz - 100 kHz |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 6 |
| Weight | 22.5 kg |
| Response Bandwidth | 10 Hz - 100 kHz |
| Input Impedance | 47 kOhm |
| Preset Station Qty | 40 |
| HDMI Switching | Yes |
| 3D Technology | Yes |
| Tuner Bands | AM, FM |
| Speaker Impedance | 8 ohms |
| FM Sensitivity | 1.0 µV |
| Amplifier Output Details | 90 W per channel (8 ohms, 20 Hz-20 kHz, 0.09% THD) |
| Tuner Type | FM/AM |
To Next Page
