FCC CERTIFICATION (USA)
While the following statements are provided to comply with FCC
Regulations in the United States, the corrective measures listed
Utilize power for the combo equipment and the device being af-
fected that are on different branch (circuit breaker of fuse) circuits,
below are applicable worldwide.
This series of Yamaha combo equipments use frequencies that ap-
pear in the radio frequency range and if installed in the immediate
proximity of some types of audio or video devices (within three
meters) interference may occur.
or install AC line filters.
In the case or radio or TV interference, relocate the antenna or, if
the antenna lead-in is 300 ohm ribbon lead, change the lead-in to
co-axial type cable.
This series of Yamaha combo equipments have been type tested and
If these corrective measures do not produce satisfactory results,
found to comply with the specifications set for a class B computing
please contact your franchised Yamaha combo equipment dealer
device in accordance with those specifications fisted in subpart J
for suggestions and/or corrective measures. If you can not locate a
of part 15 of the FCC rules. These rules are designed to provide
franchised Yamaha combo equipment dealer in your general area
a reasonable measure of protection against such interference.
contact the Combo Service Departments, Yamaha International,
However, this does not guarantee that interference will not occur. If
6600 Orangethorpe Ave., Buena Park, CA 90620, USA.
your combo equipment should be suspected of causing interference
with other electronic devices, verification can be made by turning
If for any reason, you should need additional information relating to
your combo equipment off and on. If the interference continues radio or TV interference, you may find a booklet prepared by the
when your equipment is off, the equipment is not the source of in- Federal Communications Commission helpful: “How to Identify and
terference. If your equipment does appear to be the source of the
Resolve Radio—TV Interference Problems”. This booklet is available
interference, you should try to correct the situation by using one
from the U.S. Government Printing Office, Washington D.C.
or more of the following measures:
20402—Stock No. 004-000-00345-4.
Relocate either the equipment or the electronic device that is being
affected by the interference.
.
To Next Page
