9-29
9
4. Install the differential gear oil drain bolt
and its new gasket, and then tighten the
bolt to the specified torque.
5. Refill the differential gear case with the
recommended oil.
6. Check the oil filler bolt gasket for dam-
age, and replace it if necessary.
7. Install the differential gear oil filler bolt
and its gasket, and then tighten the bolt
to the specified torque.
8. Check for oil leakage. If oil leakage is
found, check for the cause.
EBU39530
Coolant
The coolant level should be checked regular-
ly. In addition, the coolant must be changed
at the intervals specified in the periodic main-
tenance chart.
1. Differential gear oil drain bolt
2. Gasket
Tightening torque:
Differential gear oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
Tightening torque:
Differential gear oil filler bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
Recommended coolant:
YAMALUBE coolant
Coolant quantity:
Coolant reservoir (up to full level):
0.45 L (0.48 US qt, 0.40 Imp.qt)
Radiator (including all routes):
4.35 L (4.60 US qt, 3.83 Imp.qt)
UB4M11E0.book Page 29 Tuesday, August 4, 2020 1:04 PM
To Next Page
Loading...
Need help?
General
