Yamaha XT250 2008 User Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
7-36
1
2
3
4
5
6
7
8
9
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11191]
EAU24350
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
1. Turn signal light bulb
1

Yamaha XT250 2008 Specifications

General

Compression Ratio	9.5:1
Ignition	CDI
Transmission	5-speed
Final Drive	Chain
Front Suspension	35mm telescopic fork; 8.9-in travel
Rear Suspension	Single shock; 7.1-in travel
Front Brake	Single disc, 245mm
Front Tire	2.75-21
Rear Tire	120/80-18
Wheelbase	53.5 in
Seat Height	31.9 in
Fuel Capacity	2.4 gal
Curb Weight	291 lb
Ground Clearance	11.2 in
Bore x Stroke	74.0mm x 58.0mm
Fuel System	Carburetor
Rear Brake	Drum
Length	84.6 inches
Engine Type	249cc, air-cooled, 4-stroke single; SOHC, 2 valves