1
2
3
4
5
6
7
8
9
10
11
MAINTENANCE
7-7
JW3
8. After the Charged LED is illumi-
nated, disconnect the DC output
plug from the DC charger recep-
tacle by grasping the plug body
and pulling the plug straight out
of the receptacle.
Battery Installation
When working with batteries, do not
put wrenches or other metal objects
across the battery terminals. An arc
can occur causing explosion of the
battery.
1. Install the battery hold-down
plates and torque to 7-9 Nm,
0.7-0.9 m•kg (62-80 in•lb) as
shown.
å Forward
∫ Battery
ç Battery hold-down plate
2. Connect the wire leads and
torque to 9-10 Nm, 0.9-1.0 m•kg
(80-89 in•lb) as shown.
When installing batteries:
l
Carefully place battery cables
and hold-downs making sure that
cables do not lay across vent caps.
l
Always remove the negative (–)
cable to the motor controller first
and install it last.
Y-2397
B
C
A
Y-2396
JW3-F8199-00.qxp_LIT_19626_16_05.qxd 2/16/15 4:05 PM Page 39
To Next Page
Loading...
